Tips for Using Martha Stewart Potter’s Clay Paint
If you are trying to use Martha Stewart Potter’s clay paint, but if you are still need more tips to get the best result, so you are in the right place, you can just stay on this article, we will provide you a few tips to help you get the best result, so you have to consider trying to follow instruction steps below that will help you to complete and even realize your plan and also guide you to get the best result as well as your wishes. So, let’s check these out!
- For the very first, the way you have to do is protection, which is all surfaces that will not be painted by you should be protected. And then, all moldings and objects that should stay on the wall should be taped off. After that, any switch plates and outlet covers should be removed. And the last thing you have to do in the first step is a drop cloth that should be put on the floor.
- And the second way you have to do is a base coat of eggshell paint in the color corresponding that should be applied to your Otter’s Clay paint to the wall. And then, the paint should be allowed to dry completely for about twenty four hours.
- And then, the next way you have to remember is the Potter’s Clay paint that should be poured into a paint tray. And then, your 3/8 inch nap roller should be wetted by using the water, and then it should be wringed out as much excess possible. After that, your roller should be loaded by using the paint, and then it should be turned in the pan, so that it is coated evenly can be ensured.
- After that, the next point you have to do is the Potter’s Clay paint that should be rolled onto the wall. And then, the paint should be applied in a 3-foot by 3-foot W pattern. And then, the roller should be reloaded if necessary, then the roller should be brought back along the pattern, so it will be filled in. after that, this should be continued across the wall, then this coat of Martha Stewart Potter’s Clay paint should be allowed to completely dry.
- And then, the next way you have to notice is a 3-inch flat brush that should be loaded with the Potter’s Clay paint, and then a short, random X pattern should be used, so the columns of crisscrosses can be created across your wall. And then, the wet edges of each pattern should be blended, so a cohesive finish can be ensured. And then, this coat should be allowed to dry at least 24 hours.
- And the last way you have to keep in your mind is the tape from your walls and the drop cloth from your room that should be removed, and then your outlet plates and switch covers should be replaced.