Tips for Installing White Subway Wall Tiles
If you have a plan to install white subway wall tiles, however you are still need more tips to get the best result, so you are in the right place, you can just stay on this article, we will provide you a few tips to help you get the best result, so you have to consider trying to follow instruction steps below that will help you to complete and even realize your plan and also guide you to get the best result as well as your wishes. So, let’s check these out!
- For the very first, across the width of the wall should be measured, a tape measure can be used for this and the middle should be marked, a pencil can be used to solve this. And then, a vertical line at the point should be drawn, from top to the bottom. A second vertical, parallel line three inches over from the first line should be marked.
- And the second, a horizontal line should be marked across the bottom of the wall, running across the whole length of the wall and 3 ¼ inches up from the floor.
- And the next way you have to do is the bottom of the wall that should be covered; the thinset mortar can be used for this, it should be spread on with a notched trowel. You can start spreading the mortar at the floor and then come up at least a foot, the horizontal line should be covered,.
- After that, the first tile should be pressed into place under the horizontal line, with the short lined up with one of the 2 vertical lines and with the long edge on the horizontal line.
- Afterwards, more tiles should be pressed into the place next to the first one, end to end below the horizontal line, and then the spacers should be out between them as you go. And then, the whole length of the wall should be tiled, the end tiles should be cut on a tile cutter.
- And then, the second course should be set just above the first, you can start at the other vertical line than the one you began the first course with, and hanging them end to end should be started. You have to land the ends of the tiles in the second row at the middle of the tiles in the first row; a staggered brick pattern should be formed.
- And then, the wall should be tiled up, course by course, and then each course should be started at the other vertical line than the one below it.
- And the last point you have to keep in your mind is the spacers that should be pulled out. The tiles should be grouted, a grout towel can be used for this, the grout should be spread over the surface and it should be forced into the spaces between the tiles. The excess grout should be wiped up; a dampened sponge can be used for wiping. The grout should be allowed to dry at least two days.