Tips for Replacing the Shower Wall Tiles in Your Bathroom
If you have a plan to replace the shower wall tile in your bathroom, but if you are still need more tips to get the best result, so you are in the right place, you can just stay on this article, we will provide you a few tips to help you get the best result, so you have to consider trying to follow instruction steps below that will help you to complete and even realize your plan and also guide you to get the best result as well as your wishes. So, let’s check these out!
- For the very first, all the plumbing fixtures that will come off should be removed. And then, the existing wall covering should be removed. After that, a fiberglass surround should be pried off, a hammer and pry bar can be used for this. And then, the tiles should be knocked off, a hammer and chisel can be used to complete this. And then, the wall smooth and free of any mortar or glue should be scraped, a razor scraper can be used to solve this.
- And the second, the width of one wall should be measured and the center should be marked. A vertical line from top to bottom should be drawn, you should draw it at the center, a pencil and carpenter’s level can be used to draw it.
- And then, the tile mastic should be applied over the bottom one-third of the wall, from the floor up and from end to end, a notched tiling trowel should be used to this. Make this vertical line visible through the mastic should be ensured.
- And then, the first tile should be set at the bottom of the wall, on a side of the vertical line. And then, two spacers should be put below the tile, so a gap can be created between the floor and the tile. The additional tiles should be hung next to the first one; your way should be worked across the bottom of the wall.
- After that, your way should be worked up the wall, course by course.
- And the next way you have to do is the installation process that should be repeated with the other shower walls. The mastic should be allowed to set overnight.
- And then, the way you have to do is the grout that should be spread on the walls by using your grout float, and then it should be pressed into the spaces between the tiles.
- After that, the residual grout from the face of the tiles should be wiped off, a dampened sponge can be used to solve this, leaving the grouts in the joints should be ensured. The grout should be allowed to dry for about 48 hours.
- And the last, the smooth, unbroken beads of caulk should be laid, so the spaces can be filled at the floor and at the wall edges.