Tips for Replacing a Bathtub with a Walk-in Shower
If you have a plan to replace a bathtub with a walk-in shower, however you are still need more tips to get the best result, so you are in the right place, you can just stay on this article, we will provide you a few tips to help you get the best result, so you have to consider trying to follow instruction steps below that will help you to complete and even realize your plan and also guide you to get the best result as well as your wishes. So, let’s check these out!
- For the very first way you have to notice are all power and the water sources that lead to the bathroom. What should you do to them? Yes, of course they have to shut off before you start your work. And then, the water can be shut off via your house’s water remain. And then, the breaker should also be flipped or it should be switched to your bathroom on your fuse box.
- And the second way you have to do to complete this work is the old bath unit that should be pulled out. And then, if there are multiple pieces of the old unit, so it can be started at the top and then the panels, fixtures and doors should be removed. After that, the old plumbing should be disconnected once it is visible. You have to know that the unit will be strong, so some people might be asked to help you, if you have got the ones who will help you, the basin area should be directly removed.
- And then, the way you have to do to complete this work is the boards that should be replaced. And then, all of the support boards for mold or water damage or easy aging should be checked. Afterwards, they might be replaced, a more efficient, more waterproof materials can be used to solve this step, do this if needed. And then, any pieces of plumbing that are worn or damaged should be replaced.
- And the last point you have to keep in your mind is the new walk in shower unit should be installed. And then your faucet and your drain system and also and showered held should be installed. The ties or clamps or any anchors that are used by an Anchor. After that, the plumbing fixtures should also be attached. Adjust if needed. It can be sealed around the shower unit, and then the doors that should also be attached. And then, the section around the walk in shower should be re tiled or painted and then, the rails and shelves should be added.
This can be a difficult task, so having plenty of heavy lifting help available to do it safety should be ensured. So, now you can complete your plan as well by properly following instructions steps above. Don’t ever be worries, because they will work as well.