Tips for Installing a Towel Bar in a Small Bathroom
If you have a plan to install a towel bar in your small bathroom, but if you are still need more tips to get the best result, so you are in the right place, you can just stay on this article, we will provide you a few tips to help you get the best result, so you have to consider trying to follow instruction steps below that will help you to complete and even realize your plan and also guide you to get the best result as well as your wishes. So, let’s check these out!
- First, determining where you want to install your bar towel can be started. They are commonly mounted close to a shower or tub, so stretching will not be needed by you. As well to be nice to the sink. Absolutely, enough wall space will be needed by you, because the length of the bar should be accommodated.
- And the second, not to put the towel bar behind a door should be tried, since considerable damaged to each other can be done by a protruding towel bar and a swinging door.
- It should be measured up from the floor 48 inches, so the placement of the towel bar can be determined. Surely, you will never find the law that says towel bars need to be 48 inches from the floor, but it is standard. However, the height up or down can be adjusted by you to best suit the people using the bar.
- And then, the stud finder should be used. Why you have to use it? Yes, of course, because where the underlying wall studs are located along the length of bar can be found by using the stud finder, then the locations should be marked by using a piece of masking tape.
- And then, the towel should be held up to the wall with one end held over the masking and your level sitting on top of the bar.
- Because they are typically installed onto separate hardware that is hung on the walls, the actual hardware might be used as a template that where your mounting holes will be drilled should be exactly marked.
- And then, a piece of mounting hardware should be held against the masking tape and the actual spots should be marked, because the holes will be drilled, your pencil can be used to help you mark it.
- And then, the different-sized drill bits should be used to drill for the two ends. A much larger diameter hole will be required by the wall anchor or Molly bolt.
- After that, the wall fastener should be installed into the wall, then the hardware should be mounted onto the wall and the ends of the towel bar can be placed over the hardware.
- And the last, the towel bar should be attached to the mounting hardware, this can be completed by using the screws.